Categories
prototyping documentation rapid prototyping

week8: My problem, My solution

Throughout the past week an a half I have produced numerous iterations of my idea. (Just a reminder that I decided to stick with the carry-on toothbrush holder idea as I mentioned last week). 

Here are the prototypes I have produced since: 

  1. This one is interesting however bad in terms of cleaning.
  2. This one is another idea of a folding one using cardboard.
  3. This one is like the previous one but with foam
  4. With this one I was trying to find ways to achieve stability in vertical unfolded position

5.This one is the square very compact iteration.

6.Another one of my ideas.Inspired by this:

Still have some stuff to figure out! Such as:

  • how are the objects are actually going to be held (if I continue with the folding-surface idea. things that are usually used in pencil cases?  + how will the toothbrush be held in vertical position?
  • how to make the 1st option easier to clean? cause it looks the most compact. 

Leave a Reply

Your email address will not be published. Required fields are marked *