BELT SANDER
4X6 inch belt sander machine uses high-power pure copper wire winding induction motor, cast iron base, quick-change belt device, adjustable angle table, rolling sleeve bearing design with low noise, is a cost-effective sanding belt Machine, specially designed for use in schools, research institutes, studios, personal home DIY enthusiasts, small woodworking rooms; compact, ultra-low noise, stable performance, suitable for soft and hardwood, plastic and soft metal grinding, is an ideal Polishing tool.
Safety Reminder
- Be certain the belt & disk is correctly mounted! The belt must track in the center of the drums. DO NOT operate any sander if the abrasive paper is torn.
- Check the guards and the table adjustments to see that they are in the correct position and securely locked in place.
- Use the table, fence, and other guides to control the position of the work whenever possible.
- Small or irregular shaped pieces should be held in a clamp or a special jig or fixture, DO Not use your fingers.
- When sanding the end grain of a narrow piece on the disk sander, always support the work against the table.
- Sand ONLY on the side of the disc that is moving DOWN towards the table! Move the work along this surface so it will not burn.
- Always use a push stick or a block when sanding thin pieces on the disc sander.
- DO NOT use power sanders to form and shape wood where the operations could be better performed on other machines.
- Hand tightens sandpaper spindles on the spindle sander. Tightening the spindles with tools will cause the spindles to bend or break in the machine.
- Sand only clean, new wood. DO NOT sand work that has excess glue or finish on the surface. These materials will clog and ruin the sandpaper.
- Frequently wiping off or blowing off the sawdust from wood will help keep sandpaper free of clogs and keep in newer longer.